Force the carpet into the tack strip with a stiff putty knife.
Loose carpet edge.
This old house general contractor tom silva fixes a stairwell tripping hazard.
When a wall to wall carpet is installed it must be stretched tightly and then is secured in place with tack strips along the edges of the carpet.
Even new clean carpet will look old and worn if the edges aren t properly cared for.
Repeat the process along the remaining loose carpet edge.
From the tack strip and nudge the carpet tight against the wall.
Generally speaking however these aren t techniques you can do yourself.
See below for a shopping list and tools subscribe to this old house.
The place i rent has carpet.
Repeat the procedure on the other wall.
Stretch the carpet and work the edge onto the tack strip.
The most common choices for carpet finishing are binding serging and fringing.
Never pull on a loose carpet thread since this will cause the entire piece to begin.
If the installer has not stretched the carpet tightly enough it may loosen slightly which could cause it to ripple.
Trim long loose strands.
Rather it requires that you have a professional do the work with.
Use the stretcher and board if you have difficulty tightening the carpet with the knee kicker.
Also tuck the edge of the carpet into the space between the wall and the tack strip with a putty knife.
There are also a couple of pieces of this carpet placed about the place to cover up some worn areas one big one lives under a table.
If you want to make an area rug from a carpet remnant or from a swath of broadloom carpet off a roll there are several options for finishing the edges to prevent fraying.
Whether the wear and tear on your carpet edging is the result of troublesome pets or rambunctious children frayed edges are an eyesore.
Carpet buckling may occur as a result of poor installation of the carpet.